Labconco - 110610021 - 6' Protector Xstream

Labconco

110610021

6' Protector Xstream

600.00 lbs

Product Information

Specs

6' protector xstream laboratory hood with 2 service fixtures
Weight: 600.0 lbs
Weight metric: 272.0 kg
Dimensions: 72.0 inch w x 37.7 inch d x 59.0 inch h
Dimensions metric: 182.9 x 95.8 x 149.9 cm
Electrical: 208-230v 50/60 hz 5a
Product

Description

Two pre-plumbed service fixtures with forged brass valves, lower right side with brass tubing for gas and lower left side with copper tubing for cold water.Components for converting either or both fixtures to air and vacuum are provided.Inlet tubing is not provided.

The protector xstream laboratory hood takes containment, safety and energy savings to the extreme.This general chemical, high performance fume hood was independently tested and challenged well beyond the sefa-1 standards.With a face velocity of 40 fpm and sash fully open, the protector xstream was subjected to 50 fpm cross drafts, nih protocol, and tracer gas measurements in the chest of the mannequin.In all scenarios, the protector xstream allowed 0.00 ppm average level of tracer gas outside the fume hood.Although your safety officer will determine the actual face velocity setting for your laboratory, the ability of this hood to contain under these adverse conditions sets a new standard of safety.

Safety is foremost, but energy savings is equally impressive.Although face velocity is a factor, its the volumetric rate (cfm) that determines the energy consumption.Operating a 6' protector xstream at 60 fpm face

About Labconco

Labconco is a Kansas based manufacturer which makes quality laboratory equipment including hoods, cabinets, enclosures and purifiers. 

Request Information

Company: *
Name: *
Email: *
Telephone:
Product:
Message: